Engineering, 23.09.2019 00:10, Throwback633

5. the cutter bars of two combine harvesters from different manufactures develop different failure types with time. cutter bar a loses the knife sharpening after 10 seasons, while cutter bar b does not lose the knife sharpening but some blades have to be replaced time to time due to local fracture of the edge. through measuring the volume and the weight the density of both blades are around 7.8 – 7.9 kg/dm3. the hardness of the blades from a is 2.2 gpa while the hardness of the blades from b is 8 gpa. discuss two possible manufacturing differences that would lead to this situation. use suitable references to support your discussion. suggest two possible technologies to improve the life for bar a. suggest a way to reduce the brittleness of bar b. justify your suggestions and compare with real examples if possible. [hint] use heat treatment graphs, composition-mechanical properties, material data, surface engineering…

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, ahmedeldyame

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

continue

Engineering, 04.07.2019 18:10, ashleybaber4966

If a particle moves along a path such that r : (3 sin t) m and ? : 2t rad, where t is in seconds. what is the particle's acceleration in m/s in 4 seconds? a)- 16.43 b)- 16.29 c)- 15.21 d)- 13.79

Answers: 1

continue

Engineering, 04.07.2019 18:10, caitlynnpatton1208

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

continue

Engineering, 04.07.2019 18:10, ayoismeisjjjjuan

Manometers are good examples of measuring instruments, nowadays they are not as common as before. a)-capacitive probe gauges b)-gravitational gauges deformation ) gauges d)-digital gauges

Answers: 1

continue

Do you know the correct answer?

5. the cutter bars of two combine harvesters from different manufactures develop different failure t...