Engineering, 22.09.2019 02:30, mandilynn22

Question 4
a drum a of mass 200 kg, external diameter 380 mm and radius of gyration 150 mm, rotates
on frictionless bearings at 250 rev/min. a stationary drum b of mass 50 kg, external diameter
and radius of gyration 80 mm, mounted on a frictionless axis parallel to that of a is pressed into
contact with a with a force of 90 n. the coefficient of friction is 0.25. determine the time
of slipping and the final speed of a and b (ii) the time of slipping it a torque is applied on a to
maintain constant speed of 250 rev/min.
question 5
() a homogeneous cylinder(radius = 650 mm) having a mass of 15 kg has a narrow peripheral
slot cut in it at radius, 450 mm as shown in fig. q5a. a force of 80 n is exerted on a string
wrapped in the slot. the cylinder rolls without slipping. determine the frictional force, f
and the angular velocity of the cylinder after 2 s.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, settasav9641

Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.

Answers: 3

continue

Engineering, 04.07.2019 18:10, meganwintergirl

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

continue

Engineering, 04.07.2019 18:10, ijohnh14

Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way

Answers: 2

continue

Engineering, 04.07.2019 18:10, Tyrant4life

Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.

Answers: 1

continue

Do you know the correct answer?

Question 4
a drum a of mass 200 kg, external diameter 380 mm and radius of gyration 150 mm, rot...