Engineering, 18.09.2019 05:00, dewaynesmith46
Along aluminum rod with a circular cross section is attached at one end to a heated wall and transfers heat by convection to a cold fluid. if the diameter of the rod is tripled, how much would the rate of heat removal change? if the rod material is changed from aluminum to copper but all dimensions are kept the same, how much would the rate of heat removal change?
Answers: 1
Other questions on the subject: Engineering
Engineering, 04.07.2019 18:10, redrosesxx
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
Engineering, 04.07.2019 18:10, wyattlb97
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
Engineering, 04.07.2019 18:10, tobyhollingsworth178
Which from the following instrument is commonly used to detect the high pitch butzing sound in bearings? [clo4] a)-digital ultrasonic meter b)-infrared camera c)-spectroscopic d)-vibrometer
Answers: 2
Engineering, 04.07.2019 18:20, moneywaydaedae
Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis
Answers: 1
Do you know the correct answer?
Along aluminum rod with a circular cross section is attached at one end to a heated wall and transfe...
Questions in other subjects:
