Engineering, 16.09.2019 13:30, kenziepickup
A. sketch a small-signal model of the circuit in your pre-lab, replacing the transistor with its small-signal model (use the t-model and ignore r o ) . label the base of the transistor as vin j. e., the small-signal voltage at the input. what are the values of g m and ? r e what is the ratio of 172 pan you annrovimata it?
Answers: 1
Engineering, 04.07.2019 18:10, samanthabutryn
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan
Answers: 3
Engineering, 06.07.2019 03:20, shelbellingswo
Aload of 10kn is to be suddenly applied to the free end of a vertical rod of length 500 mm, the upper end being rigidly fixed. 190 mechanical science what should the diameter of the rod be if the maximum stress in the rod is not to exceed 100 mpa? the tensile modulus of the rod is 205 gpa.
Answers: 2
Engineering, 06.07.2019 04:30, hallynwright9722
At steady state, air enters an insulated duct of varying cross-sectional area (similar to a nozzle or diffuser) at 200 kpa, 52°c with a mass flow rate of 0.5 kg/s. at the duct exit, the pressure of the air is 100 kpa, the velocity is 255 m/s, and the cross-sectional area is 2 x 10-3 m^2. assuming an ideal gas model, determine: a)-find the specific volume of the air at the exit, in m3/kg. b)- the temperature of the air at the exit, in k. c)-the velocity of the air at the inlet, in m/s. d)-the inlet cross-sectional area, in m^2.
Answers: 1
A. sketch a small-signal model of the circuit in your pre-lab, replacing the transistor with its sma...
Mathematics, 24.12.2021 21:00
Mathematics, 24.12.2021 21:00
Chemistry, 24.12.2021 21:10