Engineering, 14.09.2019 05:30, hayesvolcano

Apiston- cylinder assembly for a cold air-standard otto cycle has a bore of 3 in., a stroke of 7 in., and minimum volume of 15 in^3. the maximum temperature and pressure are 1500 degrees fahrenheit and 50 lbf/in^2 , with a heat addition of 200 btu/lbm. given cv=0.171 btu/lbm degrees rankine, r=53.33 ft lbf/lbm degree rankine and m= 28.97 lbm/lbmol, determine: a. compression ratio b. specific volume at the bottom dead center (ft^3/lbm). c. temperature at the end of compression ( degree rankine). d. pressure at the end of compression ( lbf/ft^2)

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, oliviasoreo92

Compute the pressure drop of 30°c air flowing with a mean velocity of 8 m/s in a circular sheet-metal duct 300 mm in diameter and 15 m long. use a friction factor, f 0.02, and pair = 1.1644 kg/m a. 37.26 pa b. 25.27 pa n c. 29.34 pa d. 30.52 pa

Answers: 1

continue

Engineering, 04.07.2019 18:20, esmemaluma00

Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um

Answers: 2

continue

Engineering, 04.07.2019 18:20, sanchez626

Aheavily insulated piston-cylinder device contains 0.02 m3 of steam at 300 kpa and 200 °c. 1.2 mpa. d this process. team is now compressed in a reversible manner to a pressure of etermine the entropy change and the work done on the steam during this process

Answers: 1

continue

Engineering, 04.07.2019 19:20, nikkiebartels

Afan that can provide air speeds up to 60 m/s is to be used in a low-speed wind tunnel with atmospheric air at 35 c. if one wishes to use the wind tunnel to study flat-plate boundary layer behavior up to reynolds numbes of re 10, what is the minimum plate length that should be used? at what distance from the leading edge would transition occur if the critical reynolds nurnber were rer, e = 5 × 105?

Answers: 2

continue

Do you know the correct answer?

Apiston- cylinder assembly for a cold air-standard otto cycle has a bore of 3 in., a stroke of 7 in....