![Engineering](/tpl/images/cats/User.png)
Engineering, 14.09.2019 02:30, lafayette7727
Describe the differences, if any, between biot and nusselt numbers.
![answer](/tpl/images/cats/otvet.png)
Answers: 1
Other questions on the subject: Engineering
![image](/tpl/images/cats/User.png)
Engineering, 04.07.2019 18:10, anna22684
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
![image](/tpl/images/cats/User.png)
Engineering, 04.07.2019 18:10, skpdancer1605
Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2
Answers: 3
![image](/tpl/images/cats/User.png)
Engineering, 04.07.2019 18:10, keigleyhannah30
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
![image](/tpl/images/cats/User.png)
Engineering, 04.07.2019 18:10, bckyanne3
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Do you know the correct answer?
Describe the differences, if any, between biot and nusselt numbers....
Questions in other subjects:
![Konu](/tpl/images/cats/istoriya.png)
History, 14.04.2021 07:30
![Konu](/tpl/images/cats/mat.png)
Mathematics, 14.04.2021 07:30
![Konu](/tpl/images/cats/mat.png)
Mathematics, 14.04.2021 07:30
![Konu](/tpl/images/cats/mat.png)
![Konu](/tpl/images/cats/health.png)
![Konu](/tpl/images/cats/himiya.png)
Chemistry, 14.04.2021 07:30
![Konu](/tpl/images/cats/mat.png)
![Konu](/tpl/images/cats/istoriya.png)
History, 14.04.2021 07:30
![Konu](/tpl/images/cats/istoriya.png)
History, 14.04.2021 07:30
![Konu](/tpl/images/cats/istoriya.png)
History, 14.04.2021 07:30