Engineering, 14.09.2019 02:10, blxxmgrxcie

Which of the two materials (brittle vs. ductile) usually obtains the largest modulus of toughness and why?

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 19:20, diawia

Air at a pressure of 1atm and a temperature of 40 c is in parallel flow over the top surface of a flat plate that is heated to a uniform temperature of 120 c. the plate has a length of 0.40m (in the flow direction) and a width of 0.15m. the reynolds number based on the plate length is 50, 000. what is the rate of heat transfer from the plate to the air? if the free stream velocity of the air is doubled and the pressure is increased to 10 atm what is the rate of heat transfer?

Answers: 2

continue

Engineering, 06.07.2019 03:10, serenad2

Different between boring and turning?

Answers: 1

continue

Engineering, 06.07.2019 03:30, relic7391

The load on a bolt consists of an axial pull of 10 kn together with a transverse shear force of 5 kn. the bolt material has a yield strength of syt syc 100 mpa. find the diameter of the bolt at factor of safety n-0.5, n 1 and n-2 using maximum shear stress theory

Answers: 3

continue

Engineering, 06.07.2019 04:10, kraigstlistt

Agas mixture with a compostion of 55 methane, 30% propane, and 15 butane by volume) is compressed from 1 bar and 25°c to 9bar in a compressor with an isentropic efficiency of 85%. the environment has a temperature of to25 c. determine (a) the exit temperature of the mixture (b) the specific work required to run the compressor (c) the specific entropy generation of the process (d) the specific exergy destruction of the process (e) the second law efficiency of the compressor

Answers: 3

continue

Do you know the correct answer?

Which of the two materials (brittle vs. ductile) usually obtains the largest modulus of toughness an...