Engineering, 14.09.2019 02:10, braddypeter61

Two meshing 24-pitch, 25° pressure angle gears have n1-24 and n2 60 teeth. the in use center distance of the two gears is 0.16 inches larger than the design value of the center distance. what are the design value and in use value of the radius of the pitch circle of gear 1?

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, cowgyrlup124

Explain the difference laminar and turbulent flow. explain it with the shear stress and the velocity profiles.

Answers: 1

continue

Engineering, 03.07.2019 14:10, kayabwaller4589

When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point

Answers: 3

continue

Engineering, 04.07.2019 18:10, agpraga23ovv65c

Carbon dioxide gas expands isotherm a turbine from 1 mpa, 500 k at 200 kpa. assuming the ideal gas model and neglecting the kinetic and potential energies, determine the change in entropy, heat transfer and work for each kilogram of co2.

Answers: 2

continue

Engineering, 04.07.2019 18:10, 0436500

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

continue

Do you know the correct answer?

Two meshing 24-pitch, 25° pressure angle gears have n1-24 and n2 60 teeth. the in use center distanc...