Engineering, 14.09.2019 01:20, Chewbacka2020

H2 (hydrogen) is traveling through 120 ft of pipe, with 5 elbows. the psi at inlet is 10 psi higher than outlet. operating temperature at inlet is 150f (assume adiabatic flow). outlet is 10 feet below inlet. pipe is schedule 160 carbon steel with a nominal diameter of 1 inch (actual inside diameter is 0.815 inches). what is the volumetric flow rate at outlet. inlet pressure is 1810 psi, outlet is 1800 psi.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, hadellolo8839

Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false

Answers: 3

continue

Engineering, 04.07.2019 18:10, anna22684

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

continue

Engineering, 04.07.2019 19:10, juneham

Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.

Answers: 2

continue

Engineering, 06.07.2019 03:10, cicimarie2018

What is the direction and how to operate the lathe?

Answers: 2

continue

Do you know the correct answer?

H2 (hydrogen) is traveling through 120 ft of pipe, with 5 elbows. the psi at inlet is 10 psi higher...