Engineering, 14.09.2019 01:20, kaitlan225

Afluid flows upward through a vertical cylindrical of length (l) and radius (r). assume that the flow is laminar and fully developed. (a) list and describe the boundary conditions. (b) apply the continuity equation to fully developed laminar flow of an incompressible liquid in a cylinder. explain each simplification. (c) apply the continuity equation to flow of an incompressible liquid at the entrance to the cylinder- before the flow becomes fully developed. explain. (d) given the volume flow rate desired in the annulus (q), describe in detail how you would determine the required pressure difference from the entrance to exit of a straight vertical cylonder of a height (l) and radius (r). define any symbols you use not already defined.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, jojoangelique13

The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m

Answers: 2

continue

Engineering, 04.07.2019 19:20, mads000

Determine (a) the maximum thermal efficiency of reversible power cycles operating between a hot reservoir at 1000°c and a cold reservoir at 200°c and (b) the maximum cops for reversible refrigeration and heat pump cycies, respectively, between 28°c and 14°c.

Answers: 1

continue

Engineering, 04.07.2019 19:20, sashajayne8260

Determine the stoichiometric and actual air-fuel ratios and the mole flue gas composition for combustion with 15% excess air for raw indiana, pennsylvania raw coal.

Answers: 3

continue

Engineering, 04.07.2019 19:20, brae72

Asimple speed reducer is composed of 2 spur gears. the pinion gear has a pitch diameter of 0.75" and 36 teeth while the driven gear has a pitch diameter of 4.0" and 192 teeth. a)-what is the diametral pitch of each gear? b)-if an electric motor rotating ccw at 3000 rpm is coupled to the pinion, what is the rotational speed of the driven gear? c)-if the torque delivered to the pinion is 1 n-m, what is the torque on the driven gear? d)-what is the power transmitted by the gear train?

Answers: 1

continue

Do you know the correct answer?

Afluid flows upward through a vertical cylindrical of length (l) and radius (r). assume that the flo...