Engineering
Engineering, 14.09.2019 00:30, rk193140

Aheat treating process (process 1) can be added to a processing line for $30,000. the annual operating costs are $12,000 and its life is expected to be 8 years with a $10,000 salvage value at that time. an alternative process (process 2) can be installed for $21,000. its annual operating costs are $15,000 and its life is also expected to be 8 years with a $7,000 salvage value. in both cases, the annual increase in revenue due to the addition of the heat treating process is $20,000. the company's tax rate is 52% and the method of depreciation is syd. compute the rate of return of each heat treating process after depreciation and taxes. on the basis of this rate of return analysis, which alternative should be selected?

answer
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 14:10, bryneosburn
Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned
Answers: 2
image
Engineering, 04.07.2019 18:10, ashleybaber4966
If a particle moves along a path such that r : (3 sin t) m and ? : 2t rad, where t is in seconds. what is the particle's acceleration in m/s in 4 seconds? a)- 16.43 b)- 16.29 c)- 15.21 d)- 13.79
Answers: 1
image
Engineering, 04.07.2019 18:10, keigleyhannah30
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
image
Engineering, 04.07.2019 18:10, bckyanne3
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Do you know the correct answer?
Aheat treating process (process 1) can be added to a processing line for $30,000. the annual operati...

Questions in other subjects: