Engineering
Engineering, 14.09.2019 00:10, onlymyworld27

Amass of 500 kg is lowered at a constant velocity of 0.2 m/sec by means of a rope. calculate the instantaneous stress induced in the rope if (a) the rope length is 2 m when all movement is stopped at the upper end of the rope; and (b) when the rope length is 6 m (e =210 gpa).

answer
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 19:10, kayleeemerson77
Analyze the factors that influence the choice between the following pairs of processes to make the products indicated: i) sand casting versus die casting of an electric-motor housing ii) thread rolling versus machining of a bolt for high-strength application. (co3/c5)
Answers: 3
image
Engineering, 06.07.2019 03:20, mardell2587
Acountershaft is supported by two tapered roller bearings using indirect mounting. the radial bearing loads are 1120 lb for the left-hand bearing and 2190 lb for the right-hand bearing. the shaft rotates at 400 rpm and is to have an l10 life of 40,000 hours and an application factor of 1.4. assume ka2k 15, and find the required radial rating of each bearing
Answers: 3
image
Engineering, 06.07.2019 03:20, 1xXJOKERXx3
Areaction-bonded silicon nitride ceramic has a strength of 250 mpa and a fracture toughness of 3.4 mpa(m)^1/2, what is the largest-sized internal flaw that this material can support without fracturing? (use y -1 in the fracture-toughness equation.)
Answers: 3
image
Engineering, 06.07.2019 03:20, Giabear23
Major ingredients of traditional ceramics (a) silica (b) clay (c) feldspar (d) all
Answers: 1
Do you know the correct answer?
Amass of 500 kg is lowered at a constant velocity of 0.2 m/sec by means of a rope. calculate the ins...

Questions in other subjects:

Konu
Mathematics, 18.01.2020 13:31