Engineering, 13.09.2019 23:30, AngelOfLove
The compound wooden beam is connected together by at bolt at b. assuming that the connections at a, b, c. and d exert only vertical forces on the beam, determine the required diameter of the bolt at b and the required outer diameter of its washers if the allowable tensile stress for the bolt is (sigma t)allow = 150 mpa and the allowable bearing stress for the wood is (sigma b)allow = 28mpa. assume that the hole in the washers has the same diameter as the bolt.
Answers: 3
Engineering, 03.07.2019 14:10, volleyballfun24
If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.
Answers: 3
Engineering, 04.07.2019 18:10, jadeochoa4466
The temperature of air decreases as it is compressed by an adiabatic compressor. a)- true b)- false
Answers: 2
Engineering, 04.07.2019 18:10, hadellolo8839
Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false
Answers: 3
Engineering, 04.07.2019 18:10, Strick1530
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
The compound wooden beam is connected together by at bolt at b. assuming that the connections at a,...
Mathematics, 09.07.2019 03:30
Mathematics, 09.07.2019 03:30
Mathematics, 09.07.2019 03:30
Biology, 09.07.2019 03:30
Biology, 09.07.2019 03:30