Engineering, 10.09.2019 23:30, JusSomeRandomGuy
A1/10th scale model of an airplane is to be tested in a wind tunnel that operates with air at a pressure of 20 atmospheres. the plane is expected to fly at a speed of 500 [km/hr]. (a) what speed should the wind tunnel be run? (b) if the drag measured on the model is 337.5 [n], what is the corresponding drag on the full size airplane? recall that the viscosity is effectively independent upon pressure changes.
Answers: 1
Other questions on the subject: Engineering
Engineering, 04.07.2019 18:10, skpdancer1605
Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2
Answers: 3
Engineering, 04.07.2019 18:10, qwertylol12345
Different types of steels contain different elements that alter the characteristics of the steel. for each of the following elements, explain what the element does when alloyed with steel.
Answers: 2
Engineering, 04.07.2019 18:10, lillygrl100
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
Do you know the correct answer?
A1/10th scale model of an airplane is to be tested in a wind tunnel that operates with air at a pres...
Questions in other subjects:
Mathematics, 28.11.2019 21:31
