Engineering, 10.09.2019 21:30, anaaaa46
Auniform steel rod of diameter 7.5 mm is to be manufactured by a stretching process. the original diameter of the steel rod is 12.8mm. the true stress-true stain behavior of the steel is given by attmp13835. (a) is it possible to achieve the desired reduction in diameter uniformly throughout the rod length? show relevant calculations in support of your answer and (b) calculate the work done in stretching the rod till the onset of inhomogeneous (non-uniform) deformation. assume the initial length of the rod to be 50.8 mm.(reading chapter 2.12)
Answers: 1
Other questions on the subject: Engineering
Engineering, 03.07.2019 14:10, kayabwaller4589
When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point
Answers: 3
Engineering, 04.07.2019 18:10, hadellolo8839
Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false
Answers: 3
Engineering, 04.07.2019 18:10, anna22684
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
Engineering, 04.07.2019 18:10, winterblanco
The higher the astm grain-size number, the coarser the grain is. a)-true b)-false
Answers: 3
Do you know the correct answer?
Auniform steel rod of diameter 7.5 mm is to be manufactured by a stretching process. the original di...
Questions in other subjects:
Mathematics, 19.02.2020 23:34
Computers and Technology, 19.02.2020 23:34
