Engineering
Engineering, 05.09.2019 03:30, khameleonjr10

Na idade média, século v ao xv d. c., o cenário adquire um caráter místico e religioso, representando um lugar: céu, terra, inferno
porque
o espaço cênico medieval era o próprio interior da igreja, em que a representação dos dramas religiosos confundia-se com a própria liturgia.
sobre essas duas afirmativas, é correto afirmar que
a.
a primeira é uma afirmativa verdadeira; e a segunda é falsa.
b.
a primeira é uma afirmativa falsa; e a segunda é verdadeira.
c.
as duas são falsas; e não estabelecem relação entre si.
d.
as duas são verdadeiras, mas não estabelecem relação entre si.
e.
as duas são verdadeiras; e a segunda é uma justificativa correta da primeira.

answer
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 15:10, margaret1758
If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.
Answers: 1
image
Engineering, 04.07.2019 18:10, kevin72836
Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?
Answers: 2
image
Engineering, 04.07.2019 18:10, jojoangelique13
The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m
Answers: 2
image
Engineering, 04.07.2019 18:10, 0436500
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Do you know the correct answer?
Na idade média, século v ao xv d. c., o cenário adquire um caráter místico e religioso, representand...

Questions in other subjects:

Konu
Mathematics, 09.10.2021 14:00