Engineering
Engineering, 30.08.2019 21:10, nikejenkins18

Water is the working fluid in an ideal rankine cycle. steam enters the turbine at 57.4 kpa and 537.7ºc. the pressure of the condenser is 95.7 pascal and the water comes out as a saturated liquid from the condenser. the net power generated by the cycle is 293 mw. the cooling water has an increase in its temperature from 15.5ºc to 24.4ºc. a) draw the cycle on a t-s diagram. b) the mass flow of steam. c) the heat, in watio / h, that is processed to the working fluid in the boiler. d) thermal efficiencye) the mass flow of the cooling water, in kg / s.

answer
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, michellerosas
Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.
Answers: 3
image
Engineering, 04.07.2019 18:20, moneywaydaedae
Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis
Answers: 1
image
Engineering, 04.07.2019 19:10, juneham
Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.
Answers: 2
image
Engineering, 06.07.2019 03:20, 1xXJOKERXx3
Areaction-bonded silicon nitride ceramic has a strength of 250 mpa and a fracture toughness of 3.4 mpa(m)^1/2, what is the largest-sized internal flaw that this material can support without fracturing? (use y -1 in the fracture-toughness equation.)
Answers: 3
Do you know the correct answer?
Water is the working fluid in an ideal rankine cycle. steam enters the turbine at 57.4 kpa and 537.7...

Questions in other subjects:

Konu
Chemistry, 27.09.2019 16:30