Engineering, 30.08.2019 17:20, lekaje2375

Amanual assembly line is being planned for a product whose annual demand = 9 units. a continuously moving conveyor will be used with work units attached. work content time = 55 min. the line will run 50 wk/yr, 5 shifts/wk, and 8 hr/shift. each worker will be assigned to a separate workstation. based on previous experience, assume line efficiency = 0.95, balancing efficiency = 0.93, and repositioning time = 9 sec. determine: a. hourly production rate to meet the demand, b. number of workers and work station required, and c. for comparison, the ideal minimum number of workstations required (theoretical).

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, alyssabailey7545

Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines

Answers: 1

continue

Engineering, 04.07.2019 18:10, kevin72836

Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?

Answers: 2

continue

Engineering, 04.07.2019 18:20, jessie8022

Apiston-cylinder device contains 0.1 m3 of liquid water and 0.9 m3 of water vapor in equilibrium at 800 kpa. heat is transferred at constant pressure until the temperature of water reaches 350 °c. determine (a) the quality of water at the initial state (b) the work associated with this process, (c) the heat associated with this process.

Answers: 2

continue

Engineering, 04.07.2019 19:10, shunna33

Plan an experiment to measure the surface tension of a liquid similar to water. if necessary, review the ncfmf video surface tension for ideas. which method would be most suitable for use in an undergraduate laboratory? what experimental precision could be expected?

Answers: 2

continue

Do you know the correct answer?

Amanual assembly line is being planned for a product whose annual demand = 9 units. a continuously m...