Engineering
Engineering, 30.08.2019 02:10, FAKE5979

In a piece of aluminum, a 15 mm wide groove with a length of 1.5 m and a cutting depth of 5 mm must be made, due to the characteristics of the material it is recommended to have an advance of 250 mm / min, and a cutting speed of 45 m / min. if roughing is done with a 15 mm diameter end mill tool, calculate the following: a)- the rpm necessary to have a good finish, b) -the cycle time in seconds to perform the machining. c)- the volume of chips removed per minute.

answer
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 14:10, cowgyrlup124
Explain the difference laminar and turbulent flow. explain it with the shear stress and the velocity profiles.
Answers: 1
image
Engineering, 03.07.2019 23:20, abbz13
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
image
Engineering, 04.07.2019 08:10, doggo242
Which of the following is an easy way to remember the modified “x” tire rotation? a. nondrive wheels straight, cross the drive wheels b. drive wheels straight, cross the nondrive wheels c. drive wheels crossed, nondrive wheels straight d. drive wheels crossed, nondrive wheels crossed
Answers: 1
image
Engineering, 04.07.2019 18:10, wyattlb97
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
Do you know the correct answer?
In a piece of aluminum, a 15 mm wide groove with a length of 1.5 m and a cutting depth of 5 mm must...

Questions in other subjects:

Konu
Arts, 11.09.2020 23:01
Konu
Mathematics, 11.09.2020 23:01
Konu
Mathematics, 11.09.2020 23:01
Konu
Mathematics, 11.09.2020 23:01
Konu
Mathematics, 11.09.2020 23:01
Konu
Mathematics, 11.09.2020 23:01
Konu
Mathematics, 11.09.2020 23:01
Konu
Health, 12.09.2020 01:01
Konu
Mathematics, 12.09.2020 01:01