Engineering, 23.08.2019 17:20, angie0928ag

Acompound gearbox is to be designed as part of a lifting hoist. the hoist shaft must operate at 20 r. p.m. the gearbox will be driven by a motor of output power 1.2kw. the output torque from the motor is 8nm. within the gearbox, the maximum speed ratio to be used at any stage is 3: 1. the minimum number of teeth on any gear pair is 18. determine: (i)theoretical gearbox ratio (ii)number of gearbox stages needed (iii)number of teeth on all gears (iv)actual speed ratio at each stage (v)actual output torque

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, EmilySerna

Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.

Answers: 1

continue

Engineering, 04.07.2019 08:10, doggo242

Which of the following is an easy way to remember the modified “x” tire rotation? a. nondrive wheels straight, cross the drive wheels b. drive wheels straight, cross the nondrive wheels c. drive wheels crossed, nondrive wheels straight d. drive wheels crossed, nondrive wheels crossed

Answers: 1

continue

Engineering, 04.07.2019 18:10, nandalabella06

True or false (explain) (110)[111] is a slip system in bcc metals . the {111} family in fcc contains 8 planes. resolved shear stress (rss) in single crystals is just related to the applied stress. critical resolved shear stress (crss) in single crystal metals is direct proportional to the number of defects in the structure

Answers: 2

continue

Engineering, 04.07.2019 18:10, juansoto227711

Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery

Answers: 2

continue

Do you know the correct answer?

Acompound gearbox is to be designed as part of a lifting hoist. the hoist shaft must operate at 20 r...