Engineering, 22.08.2019 21:00, tomoetoes6910

For music wire, a = 2211 mpa-mmm, m = 0.145. a. what would be the tensile strength, sut, be if the wire diameter is 1.0 mm? b. how would you expect the tensile strength to vary if the diameter were doubled? would it increase, decrease or stay the same? c. what would be the tensile strength, sut, be if the wire diameter is 2.0 mm? d. how does this compare to your expectation in part b?

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, alyssabailey7545

Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines

Answers: 1

continue

Engineering, 04.07.2019 18:10, Strick1530

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

continue

Engineering, 04.07.2019 18:10, Candi9697

A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.

Answers: 2

continue

Engineering, 04.07.2019 18:20, karatsgrande3772

Determine the damped natural frequencies and the steady state response of a decoupled damped forced two degrees of freedom system. 10ä1 + 2q1 20q1 10 cos t; 10q2 +4q2 + 40q2 10 cos t

Answers: 3

continue

Do you know the correct answer?

For music wire, a = 2211 mpa-mmm, m = 0.145. a. what would be the tensile strength, sut, be if the w...