Engineering, 22.08.2019 16:20, datboi995

Aload of 2000kg is to be raised. the operator can apply a maximum effort of 735n and has a choice of 2 simple machines, see fig q2. a differential wheel and axle with a wheel diameter d= 650mm and axle diameters of d2 = 75mm and d1 = 50mm or a screw jack with a handle radius r = 380mm and screw pitch p = 25mm. i) determine which machine can be used without the risk of overhauling. (19 marks) ii) find the maximum safe load which can be raised by the machine which will overhaul with the 2000kg load.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, theamandawhite

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

continue

Engineering, 04.07.2019 18:10, samanthabutryn

Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan

Answers: 3

continue

Engineering, 04.07.2019 18:20, samueltaye

Modern high speed trains do not have perpendicular expansion gaps where rails are joined end-to-end any more they are mostly welded together but what might happen if there was a spell of particularly hot weather that causes inspection of the tracks?

Answers: 1

continue

Engineering, 04.07.2019 18:20, rbgrh9465

An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.

Answers: 3

continue

Do you know the correct answer?

Aload of 2000kg is to be raised. the operator can apply a maximum effort of 735n and has a choice of...