Engineering, 22.08.2019 16:20, nikolas36

Asteam turbine has steam flowing at steady rate of 5 kg/s entering at 5 mpa and 500 °c and leaving at 2 mpa and 140 °c. during flow through turbine a heat loss of 600 kj/s occurs to the environment at 1 atm ad 25 °c. determine 1) the availability of steam at inlet to turbine ii) the turbine output iii) the maximum possible turbine output, and iv) the irreversibility you may neglect changes in kinetic energy and potential energy during flow.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, volleyballfun24

If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.

Answers: 3

continue

Engineering, 04.07.2019 18:10, johnthienann58

Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented

Answers: 2

continue

Engineering, 04.07.2019 18:10, Strick1530

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

continue

Engineering, 04.07.2019 18:10, chadatkin

Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)

Answers: 3

continue

Do you know the correct answer?

Asteam turbine has steam flowing at steady rate of 5 kg/s entering at 5 mpa and 500 °c and leaving a...