Engineering
Engineering, 22.08.2019 02:20, Annabeans1105

Steam enters an adiabatic turbine with a pressure of 2 mpa and temperature of 250 c and leaves at 50 c. a) how much heat is transferred between the turbine and its environment? b) how much work is produced by this turbine if the process the steam experinces while passing through the turbine is internally reversible? c) what is the turbine outlet pressure if the isentropic efficiency of this turbine is 80%? d) how much work does the turbine produce if the turbine isentropic efficiency is 80%? explain the steps.

answer
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:20, rhussein6452
Wiy doeres rere okhn a pump whon working betwon the same pressure range?
Answers: 2
image
Engineering, 04.07.2019 18:20, sanchez626
Aheavily insulated piston-cylinder device contains 0.02 m3 of steam at 300 kpa and 200 °c. 1.2 mpa. d this process. team is now compressed in a reversible manner to a pressure of etermine the entropy change and the work done on the steam during this process
Answers: 1
image
Engineering, 04.07.2019 19:10, batmanmarie2004
Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.
Answers: 2
image
Engineering, 04.07.2019 19:10, santosbeti90
With increases in magnification, which of the following occur? a. the field of view decreases. b. the ambient illumination decreases. c. the larger parts can be measured. d. the eyepiece must be raised.
Answers: 1
Do you know the correct answer?
Steam enters an adiabatic turbine with a pressure of 2 mpa and temperature of 250 c and leaves at 50...

Questions in other subjects:

Konu
Mathematics, 17.12.2020 04:00
Konu
Chemistry, 17.12.2020 04:00
Konu
Mathematics, 17.12.2020 04:00