Engineering, 21.08.2019 20:20, tyryceschnitker
What is the effect of higher workpiece hardness on the formation of built-up edge, and why?
Answers: 1
Engineering, 04.07.2019 18:10, samanthabutryn
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan
Answers: 3
Engineering, 04.07.2019 18:10, 0436500
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Engineering, 04.07.2019 19:10, rhiannpelham60
The maximum shear stress and maximum flexural stress occur at the same location along a beam subjected to a non-uniform bending load. a)-trune b)- false
Answers: 2
What is the effect of higher workpiece hardness on the formation of built-up edge, and why?...
Physics, 20.09.2020 17:01
English, 20.09.2020 17:01
Mathematics, 20.09.2020 17:01
Mathematics, 20.09.2020 17:01
Engineering, 20.09.2020 17:01
Engineering, 20.09.2020 17:01