Engineering, 20.08.2019 18:30, sierram298

Consider a (9,6) swcnt that is 1000 nm long and answer the following questions. a. what is the diameter of this swcnt? [the nearest distance in the graphene sheet, b=0.142] b. what is its chiral angle? c. is this tube metallic or semiconducting? d. assuming the elastic modulus of 1500 gpa, how much the nanotube will extend if a force of 1nn or 10-9n is applied along the axis of this tube? [elastic modulus= stress/strain, stress= force/cross-section area, strain= change in length/original length] e. estimate the number of defects in a (9,6) carbon nanotube that extends from earth to international space station (iss) that is approximately 200 miles above earth. the energy needed to create a point defect is 1 ev and assume the temperature to be 300 k

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, makaylashrout77

Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.

Answers: 2

continue

Engineering, 04.07.2019 18:10, skpdancer1605

Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2

Answers: 3

continue

Engineering, 04.07.2019 18:10, Strick1530

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

continue

Engineering, 04.07.2019 18:10, wyattlb97

Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?

Answers: 3

continue

Do you know the correct answer?

Consider a (9,6) swcnt that is 1000 nm long and answer the following questions. a. what is the diame...