Engineering
Engineering, 20.08.2019 17:20, abbeygrace13

Asteam power plant operates on the rankine cycle with steam en rankine cycle with steam entering the high pressure turbine at 80 bar, 560°c with a mass flow rate of 2x10 kg/hr. the flow rate of 2x100kg/hr. the steam exits the high pressure turbine at 5 bar, 180°c where the steam is then sent back where the steam is then sent back to the boiler and reheated to 480°c before expanding through the low pressure turbine to cooling water enters the condenser from a lake at 20°c and exits at 32°c. assume the low pressure turbine has an isentropic efficiency of 92% and that the pumps opera isentropically. draw a t-s diagram of this cycle and determine the following: high pressure turbine isentropic efficiency net power output, mw low pressure turbine exit quality cycle thermal efficiency the mass flow rate of the cooling water from the lake

answer
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 16:10, Arealbot
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
image
Engineering, 04.07.2019 18:10, bckyanne3
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
image
Engineering, 04.07.2019 18:10, Fahaddie
The thermal expansion or contraction of a given metal is a function of the f a)-density b)-initial temperature c)- temperature difference d)- linear coefficient of thermal expansion e)- final temperature f)- original length
Answers: 2
image
Engineering, 04.07.2019 18:10, agpraga23ovv65c
Carbon dioxide gas expands isotherm a turbine from 1 mpa, 500 k at 200 kpa. assuming the ideal gas model and neglecting the kinetic and potential energies, determine the change in entropy, heat transfer and work for each kilogram of co2.
Answers: 2
Do you know the correct answer?
Asteam power plant operates on the rankine cycle with steam en rankine cycle with steam entering the...

Questions in other subjects: