Engineering
Engineering, 20.08.2019 17:20, keaisad12

A150 mm outer diameter by 110 mm inner diameter steel hub with 280 mm assembled on a 110 mm diameter steel shaft with a heavy press-fit.. the modulus of elasticity is to be 200gpa with a maximum clearance of 0.085mm. determine the following i) the pressure at the contact surface ii the tangential stress ii) the axial force for the system iv) the torque transmitted by the system

answer
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:20, CelesteN64
Most leaks in reciprocating air compressors can be detected and minimized by: (clo4) a)-detecting leakage areas using ultrasonic acoustic detector. b)-tightening joints and connections c)-replacing faulty equipment d)-all of the given options
Answers: 2
image
Engineering, 04.07.2019 18:20, miguel454545
Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.
Answers: 1
image
Engineering, 04.07.2019 19:10, Destinationz
Asteam is contained in a rigid tank with a volume of 1 m3. initially, the pressure and temperature are 7 bar and 500 oc, respectively. the temperature drops due to cooling process. determine: (1) the temperature at which condensation begins in °c, (2) the fraction of the total mass that has condensed when the pressure decreased to 0.5 bar. (3) the volume in m3 occupied by saturated liquid at the final state?
Answers: 3
image
Engineering, 04.07.2019 19:10, moneyyfletcher
The air in an automobile tire with a volume of 0.015 m3 is at 32°c and 140 kpa gage. determine the amount of air that must be added to raise the pressure to the recommended value of 206 kpa gage. assume the atmospheric pressure to be 128 kpa and the temperature and the volume to remain constant.[r-0.287 kj/kgk]
Answers: 3
Do you know the correct answer?
A150 mm outer diameter by 110 mm inner diameter steel hub with 280 mm assembled on a 110 mm diameter...

Questions in other subjects:

Konu
Mathematics, 06.11.2020 01:00
Konu
Mathematics, 06.11.2020 01:00
Konu
Physics, 06.11.2020 01:00