Engineering, 07.08.2019 17:20, jecorie

There is a 4-cylinder, 4-stroke internal combustion engine with a stroke of 0.08m and a bore of 0.2m. there is a clearance volume that is 14% of the cylinder volume at bottom dead center. the crankshaft rotates at 2000rpm. the process in each cylinder is modeled as an air-standard otto cycle with a pressure p = 200kpa and temperature t = 400k at the start of compression. the max temp. in the cycle is is 3000k. now, answer the following questions: 1. draw the p-v diagram of the cycle and label the temperatures and pressures given. 2. how much heat (in kj/kg) is absorbed in each cycle of one cylinder? 3. how much heat (in kj/kg) is rejected in each cycle for one cylinder? 4. what is the net work (in kj/kg) delivered in each cycle of one cylinder? ignore changes in potential or kinetic energy. 5. what is the net work (in kj) produced in each cycle for 1 cylinder? 6. what is the net power (in horsepower) generated by this engine?

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, settasav9641

Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.

Answers: 3

continue

Engineering, 04.07.2019 18:20, rocio5649

Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa. s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)

Answers: 3

continue

Engineering, 06.07.2019 02:30, onlymyworld27

In a unit cell of fcc structure, indicate the position of one of the tetrahedral interstitial sites by plotting the corresponding tetrahedron. do the same for one of the octahedral interstitial sites (in a separate fcc unit cell). mark the positions of all the tetrahedral and octahedral interstitial sites in the unit cells. how many equivalent tetrahedral sites and how many equivalent octahedral sites are contained in a fcc unit cell, respectively. what is the coordination number for a tetrahedral site and what is the coordination number for an octahedral site?

Answers: 2

continue

Engineering, 06.07.2019 03:20, mpete1234567890

Asimply supported beam abc of length l has ab of length hl and second moment of area / and bc of length hl and second moment of area i2. determine the strain energy stored in the beam when it is subject to a vertical load f at its midpoint and the consequential central deflection.

Answers: 2

continue

Do you know the correct answer?

There is a 4-cylinder, 4-stroke internal combustion engine with a stroke of 0.08m and a bore of 0.2m...