Engineering
Engineering, 06.08.2019 18:10, leelee8335

Atube-in-tube heat exchanger is used to cool engine oil by transforming heat to a flow of 40% ethylene glycol-water solution. the engine oil enters the heat exchanger at th, in= 85°c and flow through the annular space that is formed between the inner and outer tubes while the ethylene glycol flows through the inner tube. the total length of the heat exchanger is l = 12.1 m and the inner tube made of 304 stainless steel with outer diameter do = 1.0 cm and the wall thickness of 1.1 mm. the heat transfer coefficient between the engine oil and the inner tube surface is 350 w/m2-k. the ethylene glycol enters the heat exchanger at tc, in= 22°c and flows through the center tube in a counter-flow configuration with a mass flow rate of 0.012 kg/s. the fouling factor associated with the flow of the engine oil is 0.000179 k-m2/w and the fouling factor associated with the ethylene glycol is 0.00043 k-m2/w. determine the conductance (ua) of the heat exchanger

answer
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, lowkeyqueenk
Apipe with an outside diameter of 15 cm is exposed to an ambient air and surrounding temperature of -20°c. the pipe has an outer surface temperature of 65°c and an emissivity of 0.85. if the rate of heat loss from the pipe surface is 0.95 kw per meter of length, the external convective heat transfer coefficient (h) is: (a) 12.5 w/m"k (b) 18.6 w/mk (c) 23.7 w/mk (d) 27.9 w/mk (e) 33.5 w/mk
Answers: 1
image
Engineering, 04.07.2019 18:10, michellerosas
Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.
Answers: 3
image
Engineering, 04.07.2019 18:10, wyattlb97
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
image
Engineering, 04.07.2019 18:20, kendrawalraven
The characteristic roots of a dynamic system are: 1.7920 1.8160 i, -1.7920 1.8160 i, -0.4160 what is the order of this system? what are the settling time and damping ratio of the system?
Answers: 3
Do you know the correct answer?
Atube-in-tube heat exchanger is used to cool engine oil by transforming heat to a flow of 40% ethyle...

Questions in other subjects:

Konu
Mathematics, 18.02.2020 20:02