Engineering, 02.08.2019 23:10, mswillm

During the expansion process of the ideal otto cycle, the gas is a mixture whose volumetric composition is 25 percent nitrogen, 7 percent oxygen, 28 percent water, and 40 percent carbon dioxide. calculate the thermal efficiency of this cycle when the air at the beginning of the compression is at 12 psia and 55°f, the compression ratio is 5, and the maximum cycle temperature is 1600°f. use air-standard analysis. the air properties at room temperature are cp = 0.240 btu/lbm·r, cv = 0.171 btu/lbm·r, k = 1.4.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, heidiburgos1own6c0

Fluids at rest possess no flow energy. a)- true b)- false

Answers: 3

continue

Engineering, 04.07.2019 18:10, bckyanne3

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

continue

Engineering, 04.07.2019 18:10, lillygrl100

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

continue

Engineering, 04.07.2019 18:10, caitlynnpatton1208

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

continue

Do you know the correct answer?

During the expansion process of the ideal otto cycle, the gas is a mixture whose volumetric composit...