Engineering, 02.08.2019 19:20, lovly8914

A4-m-high and 6-m-wide wall consists of a long 18-cm×30-cm cross section of horizontal bricks (k=0.72w/m°c) separated by 3-cm-thick plaster layers (k=0.22w/m°c). there are also 2-cm-thick plaster layers on each side of the wall, and a 2-cm-thick rigid foam (k=0.026w/m°c) on the inner side of the wall. the indoor and the outdoor temperatures are 22°c and -4°c, and the convection heat transfer coefficients on the inner and the outer sides are h1=10w/m^2°c and h2=20w/m^2°c, respectively. assuming onedimensional heat transfer and disregarding radiation, determine the rate of heat transfer through the wall.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, hadellolo8839

Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false

Answers: 3

continue

Engineering, 04.07.2019 18:10, Larkinlover703

Items are similar to the free issue items, but their access is limited. (clo5) a)-bin stock items free issue b)-bin stock controlled issue c)-critical or insurance spares d)-rebuildable spares e)-consumables

Answers: 1

continue

Engineering, 04.07.2019 18:20, miguel454545

Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.

Answers: 1

continue

Engineering, 04.07.2019 18:20, jessie8022

Apiston-cylinder device contains 0.1 m3 of liquid water and 0.9 m3 of water vapor in equilibrium at 800 kpa. heat is transferred at constant pressure until the temperature of water reaches 350 °c. determine (a) the quality of water at the initial state (b) the work associated with this process, (c) the heat associated with this process.

Answers: 2

continue

Do you know the correct answer?

A4-m-high and 6-m-wide wall consists of a long 18-cm×30-cm cross section of horizontal bricks (k=0.7...