Engineering, 31.07.2019 00:20, jaymieordonez8751

Asmall wind tunnel in a university’s undergraduate fluid flow laboratory has a test section that is 15 by 11 inches in cross section and is 4.0 ft long. its maximum speed is 145 ft/s. some students wish to build a model 18-wheeler to study how aerodynamic drag is affected by rounding off the back of the trailer. a full-size (prototype) tractor-trailer rig is 52 ft long, 8.33 ft wide, and 12 ft high. both the air in the wind tunnel and the air flowing over the prototype are at 80 °f and atmospheric pressure. what is the largest scale model they can build to stay within the rule-of-thumb guidelines for blockage and what are the dimensions of the model truck in inches? the width of the model truck is in. the height of the model truck is in. the length of the model truck is i

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, volleyballfun24

If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.

Answers: 3

continue

Engineering, 04.07.2019 18:10, leomessifanboy678

The filament of an incandescent lamp has a temperature of 2000k. calculate the fraction of radiation emitted in the visible light band if the filament is approximated as blackbody

Answers: 2

continue

Engineering, 04.07.2019 18:10, wyattlb97

Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?

Answers: 3

continue

Engineering, 04.07.2019 18:10, mirmir62

Machinery that is a key part of the process and without which the plant or process cannot function is classifed as: (clo4) a)-critical machinery b)-essential machinery c)-general purpose machinery d)-none of the specified options.

Answers: 1

continue

Do you know the correct answer?

Asmall wind tunnel in a university’s undergraduate fluid flow laboratory has a test section that is...