Engineering, 20.07.2019 03:30, 321596
What are the major limitations of melt spinning method? a)-good for limited alloys and limited shapes b)-good for limited shapes, high cost c)-good for limited thickness and limited shapes d)-high cost, high energy consumption
Answers: 3
Engineering, 03.07.2019 14:10, volleyballfun24
If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.
Answers: 3
Engineering, 04.07.2019 16:10, TheOriginalMeyah
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
Engineering, 04.07.2019 19:10, gabigalvis1091
What is the main objective of using reheat rankine cycle?
Answers: 3
Engineering, 04.07.2019 19:20, lovenahofer
Apreheater involves the use of condensing steam at 100°c on the inside of a bank of tubes to heat air that enters at 1 atm and 25°c. the air moves at 5 m/s in cross flow over the tubes. each tube is 1 m long and has an outside diameter of 10 mm. what is the minimum value of nl needed to achieve an outlet temperature of t 75 c? what is the corresponding pressure drop across the tube bank?
Answers: 3
What are the major limitations of melt spinning method? a)-good for limited alloys and limited shap...
Mathematics, 01.11.2020 23:50
Arts, 01.11.2020 23:50
Biology, 01.11.2020 23:50
Arts, 01.11.2020 23:50
Mathematics, 01.11.2020 23:50
English, 01.11.2020 23:50
Biology, 01.11.2020 23:50