Engineering
Engineering, 20.07.2019 03:30, taryn1932

Water is the working fluid in an ideal (so compression and expansion processes are isentropic) regenerative rankine cycle with one closed feedwater heater. superheated vapor enters the turbine at 12mpa, 480°c, and the condenser pressure is 6 kpa. steam expands through the first-stage turbine where some is extracted and diverted to a closed feedwater heater at 0.7 mpa. condensate drains from the feedwater heater as saturated liquid at 0.7 mpa and is trapped into the condenser. the feedwater leaves the heater at 10 mpa and a temperature equal to the saturation temperature at 0.7 mpa. the flow rate of steam entering the first-stage turbine is 45 kg/s. determine the magnitude of the rate of heat transfer from the working fluid passing through the condenser to the cooling water, in mw.

answer
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 23:20, abbz13
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
image
Engineering, 04.07.2019 18:20, xcapo1x
Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.
Answers: 2
image
Engineering, 04.07.2019 19:10, gabrielaperezcz
Air inially occupying a volume of 1 m2 at 100 kpa, 27 c undergoes three internally reversible processes in series. process 1-2 compression to 500 kpa during which pv constant process 2-3 adiabatic expanslon to 100 kpa process 3-1: constant-pressure expansion to 100 kpa (a) calculate the change of entropy for each of the three processes. (b) calculate the heat and work involved in each process. (c) is this cycle a power cycle or refrigeration cycle?
Answers: 3
image
Engineering, 04.07.2019 19:10, nida7864
An engine, weighing 3000 n, is supported on a pedestal mount. it has been observed that the engine induces vibration into the surrounding area through its pedestal at the maximum operating speed. determine the stiffness of the dynamic vibration absorber spring in (n/m) that will reduce the vibration when mounted on the pedestal. the magnitude of the exciting force is 250 n, and the amplitude of motion of the auxiliary mass is to be limited to 2 mm note: in this question type-in right numbers, no decimals, no fractions, no unit. approximate to right number if needed
Answers: 3
Do you know the correct answer?
Water is the working fluid in an ideal (so compression and expansion processes are isentropic) regen...

Questions in other subjects:

Konu
Social Studies, 06.06.2021 02:50