Engineering, 17.07.2019 23:40, kidcashdw

An air-standard dual cycle has a compression ratio of 16 and a cutoff ratio of 1.15. at the beginning of compression, p1= factor of 2.2 during the constant volume heat addition process. if the mass of air is 0.04 kg, determine 95 kpa and t 300 k. the pressure increases by a (a)-the heat addition at constant volume and at constant pressure, each in kj (b)-the net work of the cycle, in kj. (c)-the heat rejection, in kj (d)-the thermal efficiency

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, tjeffers90028

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

continue

Engineering, 04.07.2019 18:10, bckyanne3

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

continue

Engineering, 04.07.2019 18:20, samueltaye

Modern high speed trains do not have perpendicular expansion gaps where rails are joined end-to-end any more they are mostly welded together but what might happen if there was a spell of particularly hot weather that causes inspection of the tracks?

Answers: 1

continue

Engineering, 06.07.2019 03:20, Anonymous7170

Explain in your own word the concept of a solid solution, in alloys, and how it can be created.

Answers: 3

continue

Do you know the correct answer?

An air-standard dual cycle has a compression ratio of 16 and a cutoff ratio of 1.15. at the beginnin...