![Engineering](/tpl/images/cats/User.png)
Engineering, 17.07.2019 21:10, heroxtree
Ahigh-strength cast iron bar 5-in. in diameter is being turned on a lathe at a depth-of-cut da- 0.05-in. the lathe is equipped with a 15-hp motor and has a mechanical efficiency of 80%. the spindle speed is 500 rpm. estimate the maximum feed that can be used before the lathe begins to stall?
![answer](/tpl/images/cats/otvet.png)
Answers: 3
Other questions on the subject: Engineering
![image](/tpl/images/cats/User.png)
Engineering, 04.07.2019 18:10, juansoto227711
Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery
Answers: 2
![image](/tpl/images/cats/User.png)
Engineering, 04.07.2019 18:10, QueenLife4869
Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.
Answers: 3
![image](/tpl/images/cats/User.png)
![image](/tpl/images/cats/User.png)
Engineering, 04.07.2019 19:10, nida7864
An engine, weighing 3000 n, is supported on a pedestal mount. it has been observed that the engine induces vibration into the surrounding area through its pedestal at the maximum operating speed. determine the stiffness of the dynamic vibration absorber spring in (n/m) that will reduce the vibration when mounted on the pedestal. the magnitude of the exciting force is 250 n, and the amplitude of motion of the auxiliary mass is to be limited to 2 mm note: in this question type-in right numbers, no decimals, no fractions, no unit. approximate to right number if needed
Answers: 3
Do you know the correct answer?
Ahigh-strength cast iron bar 5-in. in diameter is being turned on a lathe at a depth-of-cut da- 0.05...
Questions in other subjects:
![Konu](/tpl/images/cats/mat.png)
Mathematics, 23.10.2019 07:00
![Konu](/tpl/images/cats/mat.png)
Mathematics, 23.10.2019 07:00
![Konu](/tpl/images/cats/himiya.png)
Chemistry, 23.10.2019 07:00
![Konu](/tpl/images/cats/en.png)
![Konu](/tpl/images/cats/mat.png)
Mathematics, 23.10.2019 07:00
![Konu](/tpl/images/cats/informatica.png)
Computers and Technology, 23.10.2019 07:00
![Konu](/tpl/images/cats/mat.png)
![Konu](/tpl/images/cats/biologiya.png)
Biology, 23.10.2019 07:00
![Konu](/tpl/images/cats/istoriya.png)