Engineering, 17.07.2019 20:10, Hammon1774
A5.5-m-long simply supported timber beam carries two concentrated loads as shown. the cross-sectional dimensions of the beam are also shown. assume l1=1.1 m, l2=2.2m, p=10 kn, q=34 kn, a=135 mm, b=130 mm, c=90 mm, and d=475 mm. (a) at section a–a, determine the magnitude of the shear stress in the beam at point h. (b) at section a–a, determine the magnitude of the shear stress in the beam at point k. (c) determine the maximum horizontal shear stress that occurs in the beam at any location within the 5.5-m span length.(d) determine the maximum compression bending stress that occurs in the beam at any location within the 5.5-m span length.
Answers: 1
Other questions on the subject: Engineering
Engineering, 03.07.2019 14:10, volleyballfun24
If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.
Answers: 3
Engineering, 04.07.2019 18:10, bckyanne3
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10, wirchakethan23
Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i. d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.
Answers: 3
Do you know the correct answer?
A5.5-m-long simply supported timber beam carries two concentrated loads as shown. the cross-sectiona...
Questions in other subjects:
