Engineering, 13.07.2019 19:10, Lovelybunny321

Oil with a density of 800 kg/m3 is pumped from a pressure of 0.6 bar to a pressure of 1.4 bar, and the outlet is 3 m above the inlet. the volumetric flow rate is 0.2 m3/s, and the inlet and exit areas are 0.06 m2 and 0.03 m3, respectively. (a) assuming the temperature to remain constant and neglecting any heat transfer, determine the power input to the pump in kw. (b) what-if scenario: what would the necessary power input be if the change in ke were neglected in the analysis? ?

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, chadatkin

Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)

Answers: 3

continue

Engineering, 04.07.2019 19:10, phantomlizz3233

In general, how do thermosetting plastics compare to thermoplastics in mechanical and physical properties?

Answers: 3

continue

Engineering, 06.07.2019 04:30, jess2652

Calculate the equilibrium concentration of vacancies per cubic meter in pure aluminum at 500°c. assume that the energy of formation of a vacancy in pure aluminum is 0.76 ev. what is the vacancy fraction at 650°c.

Answers: 3

continue

Engineering, 06.07.2019 05:10, NycLife

The constant-pressure specific heat of air at 25°c is 1.005 kj/kg.°c. express this value in kj/kg k, jg c, kcalk. c, and btu/lbm °f.

Answers: 1

continue

Do you know the correct answer?

Oil with a density of 800 kg/m3 is pumped from a pressure of 0.6 bar to a pressure of 1.4 bar, and t...