Engineering, 12.07.2019 22:30, artursino
Asteel bar 100 mm long and having a square cross section of 20 mm on an edge is pulled in tension with a variable load similar to a tensile test. if the bar started its plastic deformation when the load was 90 n, at which the bar elongated 1 mm. in addition, the bar started necking at 200n, at which the elongation was measured to be 3 mm. calculate the following mechanical parameters: a)- yield strength b)-young's modulus of elasticity c)-engineering tensile strength d)-strain-hardening coefficientstrength coefficient
Answers: 2
Engineering, 04.07.2019 18:10, Strick1530
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
Engineering, 04.07.2019 18:10, oliviasoreo92
Compute the pressure drop of 30°c air flowing with a mean velocity of 8 m/s in a circular sheet-metal duct 300 mm in diameter and 15 m long. use a friction factor, f 0.02, and pair = 1.1644 kg/m a. 37.26 pa b. 25.27 pa n c. 29.34 pa d. 30.52 pa
Answers: 1
Engineering, 04.07.2019 18:20, hayleymckee
Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent
Answers: 2
Asteel bar 100 mm long and having a square cross section of 20 mm on an edge is pulled in tension wi...
Mathematics, 20.08.2019 12:50
Biology, 20.08.2019 12:50