Engineering, 11.07.2019 02:20, JellalFernandes

Consider a steady state heat flow through a 12 feet x 14 feet brick wall of thickness 15 inches and thermal conductivity 1.5 btu/(hr-ft-f). on a day when the temperature of the outdoor is 32 f, the house is maintained at 78 f. the temperatures of the inner and outer surfaces of the brick wall are to be 68 f and 41 f, respectively. determine the rate of entropy generation in the wall and the total rate of entropy generation associated with this heat transfer process

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, juansoto227711

Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery

Answers: 2

continue

Engineering, 04.07.2019 18:20, Doogsterr

For each of the following process: a) sketch the p-v diagram, b)sketch t-s diagram, c) sketch t-v diagram, d) sketch the boundary work on one of the diagrams (a, b or c) and e) sketch the reversible heat transfer on one of the diagrams (a, b or c): 1- isobaric process from compressed liquid to superheated vapor 2- isothermal process from compressed liquid to superheated vapor 3- isentropic process from compressed liquid to superheated vapor

Answers: 3

continue

Engineering, 04.07.2019 19:20, holaadios222lol

Apiping systems consists of 6 m of 6-std type k and 12 m of 4-std type k, both drawn copper tubing. the system conveys ethylene glycol at a rate of 0.013 m3/s. the pressure drop across the system is to be calculated. there are two 90° elbows in the 6-in pipe, a reduction from the 6-in pipe to the 4-in pipe and four 90° elbows in the 4-in pipe. all fittings are soldered (same as flanged) and regular. the inlet and outlet of the system are at the same height.

Answers: 1

continue

Engineering, 06.07.2019 02:30, heavenwagner

A12 mm diameter shaft runs in a plain cylindrical bush 30 mm long that is located in an 18 mm diameter hole in a housing. the shaft-inner bush fit is h8 f and the outer bush-housing fit is h7-p6. make a fully cimensioned sketch of the bush with tolerances. find the maximum and minimum clearance or interference for both fits on the inner and outer diameters of the bush

Answers: 3

continue

Do you know the correct answer?

Consider a steady state heat flow through a 12 feet x 14 feet brick wall of thickness 15 inches and...