Engineering
Engineering, 11.07.2019 01:20, haleysmith8608

Anovelty golf ball of mass m is launched with an initial velocity vo (25i-13j) m/s and then follows a parabolic trajectory. at the top of the ball's trajectory, it explodes into two fragments a and b. fragment a has mass ma 1/3 m and is stationary immediately after the explosion, while fragment b has mass mb-2/3 m and has non-zero velocity vb immediately after splitting from fragment a. in answering the following questions, ignore air resistance and assume the terrain over which the ball and fragments fly is level. [taken from 2015 exam (a) how many seconds after the launch does the ball attain its maximum height? (b) what is the velocity v of the ball immediately prior to the explosion? (c) what is the velocity of fragment b immediately before it hits the ground? express your answer in unit vector form

answer
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, ijohnh14
Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way
Answers: 2
image
Engineering, 04.07.2019 18:10, Strick1530
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
image
Engineering, 04.07.2019 18:20, aly95
An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid
Answers: 3
image
Engineering, 04.07.2019 18:20, cristykianpour
Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?
Answers: 2
Do you know the correct answer?
Anovelty golf ball of mass m is launched with an initial velocity vo (25i-13j) m/s and then follows...

Questions in other subjects: