Engineering, 06.07.2019 03:20, carrietaylor234

Avertical steel rod of length 2.0 m and diameter 25 mm is rigidly fixed at its upper end and has a flange at its lower, free, end. what will be the maximum stress produced in the rod when a load of 20 kn is applied, (a) gradually to the lower end, (b) suddenly to the lower end, (c) by a collar falling from a height of 50 mm on to the flange?

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 16:10, TheOriginalMeyah

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Answers: 2

continue

Engineering, 04.07.2019 18:10, tjeffers90028

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

continue

Engineering, 04.07.2019 18:10, samanthabutryn

Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan

Answers: 3

continue

Engineering, 04.07.2019 18:10, krystabrewer3

What are the two (02) benefits, which may result from a successful implementation of preventive maintenance (pm) program in an organization? (clo3)a)- lean manufacturing b)-overlapping responsibilities c)-the planner is not qualified d)-accurate contractor information e)-reduction in equipment redundancies f)-accurate stores information

Answers: 3

continue

Do you know the correct answer?

Avertical steel rod of length 2.0 m and diameter 25 mm is rigidly fixed at its upper end and has a f...