Computers and Technology, 30.12.2021 22:10, meababy2009ow9ewa
What is printed out as a result of executing the code segment cs ap12 ap cs3 csap 12 apcs 12 apcs 3
Answers: 3
Computers and Technology, 22.06.2019 03:30, raytaylorh010801
Write a computer program to calculate the three-phase fault current for a fault at f in figure 1.16, with the network normal, and with one line at a time removedproblems 1.1 write a computer program to calculate the three-phase fault current for a fault at f in figure 1.16, with the network normal, and with one line at a time removed 20 power system relaying from service. the positive-sequence impedance data are given in the accompanying table. use the commonly made assumption that all prefault resistance values are (1.0+j0.0) pu, and neglect all resistance values. calculate the contribution to the fault flowing through the cb b and the voltage at that bus. for each calculated case, consider the two possibilities: cb b2 closed or open. the latter is known as the stub-end fault Ă• figure 1.16 problem 1.1 system data for figure 1.16 from to positive sequence 0.0+j0.1 0.05j0.15 0.04 j0.2 0.01 jo. i 0.015 + j0.15 0.01 j0.19 0.01 +j0.19 0.03+j0.1 0.0+j0.08 6 6 6 from service. the positive-sequence impedance data are given in the accompanying table. use the commonly made assumption that all prefault resistance values are (1.0 + j 0.0) pu, and neglect all resistance values. calculate the contribution to the fault flowing through the cb b1, and the voltage at that bus. for each calculated case, consider the two possibilities: cb b2 closed or open. the latter is known as the “stub-end” fault.
Answers: 2
Computers and Technology, 22.06.2019 20:40, broang23
Write a program that begins by reading in a series of positive integers on a single line of input and then computes and prints the product of those integers. integers are accepted and multiplied until the user enters an integer less than 1. this final number is not part of the product. then, the program prints the product. if the first entered number is negative or 0, the program must print “bad input.” and terminate immediately. next, the program determines and prints the prime factorization of the product, listing the factors in increasing order. if a prime number is not a factor of the product, then it
Answers: 2
Computers and Technology, 23.06.2019 10:30, tommyaberman
Would a ps4 wired controller work on an xbox one
Answers: 1
What is printed out as a result of executing the code segment cs ap12 ap cs3 csap 12 apcs 12 apcs 3...
Mathematics, 02.03.2021 20:00
Mathematics, 02.03.2021 20:00
Mathematics, 02.03.2021 20:00