Which of these examples is correct !?

:you areto design the controller for alight that functions both as an ordinary light and also as a motion activated light and alarm. a. if the manual switch s is on, then the light l is on. b. besides the manual switch, there is a motion detector, m1, which activatesthis light. c.if motion is detected but the light is on anyway because s is on, only then a secondoutput a, an alarm, is turned on. d. the disable switch, d, disables the motion activated light and alarmbut leaves manual control operation of the light using switch s.(i)read the problem statement and clearly identify the inputs and outputs for the circuit you are designing. (ii)create the truth table for this system; include the light, alarm, switch, disable, and the motion sensor.(iii)draw a schematic of this system.

1. which of the following statements are true about routers and routing on the internet. choose two answers. a. protocols ensure that a single path between two computers is established before sending packets over it. b. routers are hierarchical and the "root" router is responsible for communicating to sub-routers the best paths for them to route internet traffic. c. a packet traveling between two computers on the internet may be rerouted many times along the way or even lost or "dropped". d. routers act independently and route packets as they see fit.

Use a physical stopwatch to record the length of time it takes to run the program. calculate the difference obtained by calls to the method system. currenttimemillis() just before the start of the algorithm and just after the end of the algorithm. calculate the difference obtained by calls to the method system. currenttimemillis() at the start of the program and at the end of the program so that the elapsed time includes the display of the result. use the value returned by the method system. currenttimemillis() just after the end of the algorithm as the elapsed time.