Computers and Technology, 25.08.2021 23:10, lackin2056

Which of the following was a limitation of the Harvard Mark I created by IBM? 1. It used mechanical relays which were slow and could break down after repetitive use.

2. It could only calculate addition ad subtraction problems instead of complex problems.

3. It calculated too quickly.

4. It was too small for engineers to use for calculations.

Answers: 2

Show answers

Other questions on the subject: Computers and Technology

Computers and Technology, 24.06.2019 00:00, BluedragonKBT44

The gene form of a trait is called a(n)

Answers: 2

continue

Computers and Technology, 24.06.2019 08:50, bo4isbad

Write a program that will compute the volume of ice cream served in a cone. as you can see in the diagram below, the ice cream is served as a hemisphere of frozen deliciousness on top of a cone, which is also packed with frozen deliciousness. thus, the total volume of ice cream sold is the volume of the hemisphere plus the volume of the cone. the example shows an ice cream cone in which the hemisphere and cone have a radius of 10 inches and the cone has a height of 15 inches. your program must instead prompt for these two values, which are taken from the keyboard as integers: • the hemisphere/cone radius in inches, and

Answers: 3

continue

Computers and Technology, 24.06.2019 15:30, jhony70

What type of forensic evidence was recovered during the bomb set off at the new mexico facility on the video that was similar to the evidence obtained at the boston bombings and how did the evidence allow the researchers to connect other pieces of evidence to the same bomb?

Answers: 2

continue

Computers and Technology, 24.06.2019 16:00, miner12924owhu4d

5.a fishing rod is formed from a composite material of 0.5 kg of glass fibers embedded in a matrix of 0.5 kg of epoxy resin. the glass fibers are assumed to be long, continuous and unidirectional. to achieve a greater stiffness it is proposed to use a different composite that is comprised of long continuous carbon fibers that will be embedded in a matrix of 0.5 kg of epoxy resin. if the modulus of elasticity of the carbon fiber composite is 10% greater than the elastic modulus of the glass fiber composite, estimate the mass of carbon fibers that will be used to make the carbon fiber composite. assume the applied tensile stress is parallel to the direction of the long axis of the fibers. the epoxy resin, glass fiber, and carbon fiber have an elastic modulus of 5, 86, and 350 gpa respectively and a density of 1100, 2500, and 1800 respectively.

Answers: 3

continue

Do you know the correct answer?

Which of the following was a limitation of the Harvard Mark I created by IBM? 1. It used mechanica...