When you borrow money to buy a house, a car, or for some other purpose, then you typically repay it by making periodic payments. Suppose that the loan amount is L, r is the interest rate per year, m is the number of payments in a year, and the loan is for t years. Suppose that i = (r / m) and r is in decimal. Then the periodic payment is: R=Li/1-(1+i)-^mt
You can also calculate the unpaid loan balance after making certain payments. For example, the unpaid balance after making k payments is:
R=Li/1-(1+i)-^mt
where R is the periodic payment. (Note that if the payments are monthly, then m = 12.)
Instructions:
Write a program that prompts the user to input the values of L, P, M, t, and k. The program then outputs the appropriate values. Your program must contain at least two functions, with appropriate parameters, to calculate the periodic payments and the unpaid balance after Programming

Determine which of the four levels of measurement (nominal, ordinal, interval, ratio) is most appropriate for the data below. internet speed levels of "fast comma " "medium comma " and "slow" choose the correct answer below. a. the ordinal level of measurement is most appropriate because the data can be ordered comma but differences left parenthesis obtained by subtraction right parenthesis cannot be found or are meaningless. nothing nothing nothing nothing nothing b. the interval level of measurement is most appropriate because the data can be ordered comma differences left parenthesis obtained by subtraction right parenthesis can be found and are meaningful comma and there is no natural starting point. c. the nominal level of measurement is most appropriate because the data cannot be ordered. nothing d. the ratio level of measurement is most appropriate because the data can be ordered comma differences left parenthesis obtained by subtraction right parenthesis can be found and are meaningful comma and there is a natural starting point.

Usually, when we sniff packets, we are only interested certain types of packets. we can do that by setting filters in sniffing. scapy’s filter use the bpf (berkeley packet filter) syntax; you can find the bpf manual from the internet. set the following filters and demonstrate your sniffer program again (each filter should be set separately): (a) capture only the icmp packet. (b) capture any tcp packet that comes from a particular ip and with a destination port number 23. (c) capture packets comes from or to go to a particular subnet. you can pick any subnet, such as 128.230.0.0/16; you should not pick the subnet that your vm is attached to.

In a response of approximately 50 words, explain why it would be essential for the successful a/v technician to participate in additional coursework, presentations and seminars offered by equipment manufacturers as well as annual conferences attended by colleagues in the industry.