The O’Neill High School Performing Arts Center auditorium contains 20 rows (numbered 1 through 20) with 40 seats each (numbered 1 through 40). Write an application that allows a user to continuously enter a row and seat request until a sentinel value is entered. If the row or seat number is too high, issue an error message. Otherwise, determine whether the seat has already been reserved. If so, display an error message; if not, then charge the user $7.50 for a ticket and display a running total of the user’s purchase. When the user enters a sentinel, display the number of seats taken and the number still available in the auditorium.

Write a program that displays the following menu: geometry calculator 1. calculate the area of a circle 2. calculate the area of a rectangle 3. calculate the area of a triangle 4. quit enter your choice (1-4): if the user enters 1, the program should ask for the radius of the circle and then display its area. use the following formula: area = ď€(the square of r) use 3.14159 for ď€ and the radius of the circle for r. if the user enters 2, the program should ask for the length and width of the rectangle and then display the rectangle’s area. use the following formula: area = length * width if the user enters 3, the program should ask for the length of the triangle’s base and its height, and then display its area. use the following formula: area = base * height * .5 if the user enters 4, the program should end. input validation: display an error message if the user enters a number outside the range of 1 through 4 when selecting an item from the menu. do not accept negative values for the circle’s radius, the rectangle’s length or width, or the triangle’s base or height. note: if the user enters an improper menu choice (1-4), the program prints "the valid choices are 1 through 4. run the program again and select one of those." if the user enters a negative radius, the program prints "the radius can not be less than zero." if the user enters a negative value for height or base, the program prints "only enter positive values for base and height."