DDR III SDRAM (Double Data Rate III Synchronous Dynamic RAM) có tốc độ bus 800/1066/1333/1600 Mhz, số bit dữ liệu là 64, điện thế là 1.5v. Chuẩn giao tiếp của DDR III SDRAM là?

Check my work the microprocessor is a(n) circuit, which is designed to process data based on a set of instructions. most desktop and laptop devices contain a microprocessor based on the standard. most tablets and smartphones contain processors based on technology. a microprocessor's circuitry is designed to perform a limited number of tasks contained in its set. during processing, an instruction is loaded into the processor's unit. data is loaded into registers in the processor's where arithmetic and logic operations are performed. microprocessor performance can be measured by its speed. other factors affecting overall processing performance include word size, cache size, and instruction set complexity. most digital devices contain only one microprocessor chip, but today's multi- processors contain circuitry that supports parallel processing. computers contain various kinds of memory. random memory is a special holding area for data, program instructions, and the system. it stores data on a temporary basis until the processor makes a data request. ram is different from disk storage because it is , which means that it can hold data only when the computer power is turned on. computers also contain read- memory, which is a type of non-volatile memory that provides a set of "hard-wired" instructions, called the loader, that a computer uses to boot up.

Read the code below. what will the computer print if the input for year_variable is 1700? if year_variable == 1776: print("your answer is correct. the declaration of independence was signed in “year_variable”.") elif year_variable < 1776: compute_variable = 1776 - year_variable. print("add “compute_variable“ years to your answer for the correct answer.") elif year_variable > 1776: compute_variable = year_variable - 1776 print("subtract “compute_variable” years from your answer for the correct answer.")

Which of the following commands is more recommended while creating a bot?