Consider the following code: int Num1 = 5.2;

int Num2 = 3;

int Result;

void setup() {

// put your setup code here to run once:

Serial. begin(9600);

Result = Num1 * Num2;

}

void loop() {

// put your main code here to run repeatedly:

}

What is the result value after executing the code? Is it correct? Justify your answer.

Look at the far left lane in the picture. explain what the red car is doing and what it needs to do to travel safely.

The instruction ishl (shift left integer) exists in jvm but not in ijvm. it uses the top two values on the stack, replacing the two with a single value, the result. the sec- ond-from-top word of the stack is the operand to be shifted. its content is shifted left by a value between 0 and 31, inclusive, depending on the value of the 5 least signifi- cant bits of the top word on the stack (the other 27 bits of the top word are ignored). zeros are shifted in from the right for as many bits as the shift count. the opcode for ishl is 120 (0x78).a. what is the arithmetic operation equivalent to shifting left with a count of 2? b. extend the microcode to include this instruction as a part of ijv.

What is the first view you place in your drawing?